50 EN WM 100 TD
WM 67841c 03/2015
5 Operation
5.7 Switching softSTART on/off
The softSTART function makes it easier to get used to the
ventilation pressure when falling asleep. You can set a pressure
different to the prescribed therapy pressure. When switched on,
the therapy device sets this softSTART pressure. The pressure then
increases slowly within the specified period or drops after the
specified period (maximum 45 minutes) to the therapy level.
This function is suitable for patients who find a high or low
pressure uncomfortable when awake and cannot fall asleep.
Requirement • The softSTART function has been enabled by the physician or
authorized dealer.
• A softSTART pressure is set (see "6.1 Setting comfort
parameters", page62).
1. Start the therapy (see "5.4 Starting the therapy", page46).
2. If softSTART was activated during the last therapy: softSTART
starts automatically when the therapy starts.
or
Press the softSTART button to switch softSTART on.
The remaining time in minutes is shown.
3. Press the softSTART button to switch softSTART off.
The set softSTART time in minutes is shown.
When running, a mask test will only interrupt softSTART and it will
be restarted after the mask test.
To Next Page
Loading...
Need help?
General
