WM 67841c 03/2015
WM 100 TD EN 65
6 Settings in the menu
6.4 Setting device parameters
You can use the device parameters to set the brightness of the
display and the volume of the acoustic signals among other things
as you wish.
Requirement The therapy device is in Standby mode.
1. Press the menu button .
2. Press the Device field.
3. Configure the required settings and confirm.
Parameter Possible values Description
Display
brightness
1
2
3
Here you can set the brightness of the display.
• Level 1: Dark
• Level 2: Normal
• Level 3: Bright
Leakage
alert
Off
On
Here you can set whether an alarm should be triggered in case
of a leak. This allows you to change the position of your mask
at night. By doing so you avoid side effects or a reduced therapy
quality due to severe leaks.
If it is not possible to select this function, it must be enabled by
your physician or authorized dealer.
Energy saving
Off
On
Here you can activate or deactivate whether the therapy device
automatically switches to Energy saving mode 15 minutes
after the therapy has finished.
You save electricity if the therapy device is in Energy saving
mode during the day.
Key tone volume
Off
1
2
3
Here you can set the volume of the acoustic signal for every time
a key is pressed or switch the signal off.
• Level 1: Quiet
• Level 2: Normal
• Level 3: Loud
Alarm volume
1
2
3
Here you can set the volume of the alarms.
• Level 1: Quiet
• Level 2: Normal
• Level 3: Loud
Alarm clock
volume
Off
1
2
3
Here you can set the volume of the alarm.
• Level 1: Quiet
• Level 2: Normal
• Level 3: Loud
To Next Page
Loading...
Need help?
General
