Weinmann prisma25ST User Manual

WM 67841c 03/2015
WM 100 TD EN 81
9 Alarms and error messages
9.3 Faults in the respiratory air humidifier
9.4 Display messages
If the message Error (xxx): Please follow the instructions in
the Instructions for use appears on the display, locate the
displayed error code in the table. Rectify the error as described.
Fault Cause Remedy
The respiratory air humidifier
is not heating up.
Humidifier level switched off
Set the humidifier level (see 5.8.3,
p.53).
The respiratory air humidifier is
defective
Have therapy device repaired.
Respiratory air humidifier is
leaking.
The seal on the element is defective. Replace the seal (see 7.5.2, p. 74).
The humidifier insert is not inserted
correctly.
Insert the humidifier insert correctly
(see 7.5, p. 70).
The humidifier insert is defective. Replace the humidifier insert.
Cracks in the base of the humidifier Replace the base of the humidifier.
Respiratory air humidifier
switches off.
No water in the respiratory air
humidifier.
Fill the respiratory air humidifier with
water (see , p. 34).
Error code Cause Remedy
(108)
The therapy device does not
display the set time.
Contact the authorized dealer and have the device repaired.
(204)
The respiratory air
humidifier is not working
correctly.
Remove the respiratory air humidifier from the therapy device
and connect it again (see 4.3.3, p. 38).
If the message is still shown, contact the authorized dealer
and have the device and the respiratory air humidifier
checked.
(205)
The power supply voltage is
not within the permitted
range.
Check whether the correct power supply unit is connected
(WM 29657).
Contact the authorized dealer and have the
device and power supply unit checked and repaired.

Weinmann prisma25ST Specifications

General

Brand	Weinmann
Model	prisma25ST
Category	Health Care Products
Language	English