WM 67841c 03/2015
WM 100 TD EN 59
5 Operation
2. Slide the SD card into the SD card slot until it audibly clicks into
place.
When doing so, note: The beveled corner of the SD card must
be at the top and facing the device during insertion.
3. Close the SD card slot cover.
Result The SD card is inserted in the therapy device and ready for use.
After the device is switched on, the SD card symbol appears in
the status line of the display.
5.11.2 Saving therapy data to the SD card
Autosave
The therapy device saves the therapy data automatically in the
following events:
• Each time you end a therapy.
• Each time you insert an SD card. Only insert SD cards when the
device is in Standby mode.
• When the therapy device is reconnected to the power supply
after a saving process is interrupted.
Data loss in case of power loss!
Data may be lost if the therapy device is disconnected from the
power supply during the saving process.
Keep the therapy device connected to the power supply during
the saving process (SD card symbol flashes).
To Next Page
Loading...
Need help?
General
