2-3
Section 2 Installation
n
Caution
DO NOT position the UHCTHD near the steam or heat
exhaust of another appliance.
Install Cord hanger
Install cord hanger on units with a rear-exit power
cord. See instructions with kit 8262717, which
shipped with cabinet. A zip tie holds it in place.
Connect to power
Plug the UHCTHD into the power source.
Product Trays
The UHCTHD has six rows, which hold up to three
trays of product each or three rows, which hold three
trays each.
There are 5 product tray sizes:
A. 1/3-size plastic tray
B. 1/3-size wire tray
C. Full-size plastic tray
D. 2/3 size plastic tray
E. 1/2 size plastic tray
Use in conjunction with your country’s operation and
training manual.
Important Operational Tips
When placing a tray into the cabinet, make sure the
row line on the tray handle lines up with the edge of
the row.
Discard cracked or damaged trays.
When removing portions from a tray, slide the tray
only as far as needed, and then quickly return the
tray to the slot line.
Check your local ops for chart layouts for the
UHCTHD.
Place empty food trays in all row positions
Install Grill Clip
The grill clip is designed to hold the 1/3-size grill tray.
It attaches to the grill to make transfer from the grill
to the UHCTHD faster and
safer.
• Position the front of the
grill clip under the lip of
the grill.
• Lower the back of the
clip until the grooves
rest over the grill bar.
The grill clip should
firmly seat on the front
of the grill. If the clip
doesn’t fit snuggly,
simply loosen the four nuts under the clip and
slide it in or out as needed to tighten against the
bar. Tighten the nuts after the clip is properly
adjusted.
To Next Page
