4-1
DANGER
All utility connections and fixtures must be maintained
in accordance with local and national codes.
DANGER
It is the responsibility of the equipment owner to
perform a Personal Protective Equipment Hazard
Assessment to ensure adequate protection during
maintenance procedures.
DANGER
Failure to disconnect the power at the main power
supply disconnect could result in serious injury or death.
The power switch DOES NOT disconnect all incoming
power.
DANGER
Disconnect electric power at the main power disconnect
for all equipment being serviced. Observe correct
polarity of incoming line voltage. Incorrect polarity can
lead to erratic operation.
n
Warning
When using cleaning fluids or chemicals, rubber gloves
and eye protection (and/or face shield) must be worn.
,
Caution
Maintenance and servicing work other than cleaning as
described in this manual must be done by an authorized
service personnel.
Cleaning and Preventative Maintenance
Procedures
GENERAL
You are responsible for maintaining the equipment
in accordance with the instructions in this manual.
Maintenance procedures are not covered by the
warranty.
Maintenance
Every 4
Hours
Daily After
Prolonged
Shutdown
Start-Up
Exterior - X X X
Interior - X X X
Plastic Trays
and Racks
X X X X
EVERY FOUR (4) HOURS – CLEAN TRAYS/RACKS
1. Remove all plastic and wire trays. Take trays/
racks to the sink for cleaning.
2. Clean trays by washing in a hot McD All-Purpose
Super Concentrate (APSC) solution drawn
through the sink proportioner or mix 0.3 fl. McD
APSC for each gallon of solution. Rinse trays/
racks thoroughly under hot water.
3. Sanitize trays/racks by dipping in McD Sink
Sanitizer (HCS) solution, (one pack per 10 gallons
of water) or McD Sanitizer (HCS) solution (four
packs per 10 gallons of water), for at least 1
minute. Remove from sanitizer solution and
allow to air dry.
DAILY - CLEAN CABINET
1. At the end of the operating day, ensure all
holding times are complete or canceled (see page
3-3 to cancel hold times).
2. Press the Clean Mode button.
3. The unit displays Enter Cleaning
Mode?. Press the check mark to
continue.
Section 4
Preventative Maintenance
To Next Page
Loading...
Need help?
General
