4-2
Maintenance Section 4
4. The unit displays COOLING DOWN while the
cabinet is cooling.
Note: DO NOT use McD Sink Sanitizer (HCS) to
clean the exterior of the Universal Holding
Cabinet.
5. Let the unit cool until the unit displays Safe to
Clean.
6. Use the cabinet cleaning brush to remove any
remaining buildup on the slot surface by pushing
all loose particles out the opposite end of the
cabinet.
Note: Use only the cabinet cleaning brush to
clean the cabinet slots. Wire brushes, abrasive
pads, or metal scrapers will permanently damage
the surface of the cabinet slot.
Note: Do Not use any other cleaner than McD
All-Purpose Super Concentrate (APSC). Using other
compounds may result in damage to control
components.
7. Use a wet, clean/sanitized towel and the cabinet-
cleaning brush to clean each slot. Clean the
bottom and top surface of each slot.
8. Wipe clean all exterior cabinet surfaces with
a clean, sanitized towel that has been soaked
in McD All-Purpose Super Concentrate
(ASPC).
9. Press the lock button to clean the
screen.
10. The unit displays the lock
counter. While the screen is
locked it can be cleaned.
11. Press the return button.
12. The unit displays Exit
Clean?.
13. Press the check button
to exit.
14. Turn the unit off.
n
Warning
Never use a high-pressure water jet for cleaning or hose
down or flood interior or exterior of units with water. Do
not use power cleaning equipment, steel wool, scrapers
or wire brushes on stainless steel or painted surfaces.
,
Caution
Never use an acid based cleaning solution on exterior
panels! Many food products have an acidic content,
which can deteriorate the finish. Be sure to clean the
stainless steel surfaces of ALL food products.
,
Caution
Do not use caustic cleaners on any part of the holding
cabinet or holding cabinet cavity . Use mild, non abrasive
soaps or detergents, applied with a sponge or soft cloth.
Never use sharp implements or harsh abrasives on any
part of the holding cabinet.
To Next Page
