22
Required tools:
Cart
- 7/16” socket and open-end wrench
- Phillips head torque screwdriver
- T25 socket driver
- 3/8" socket
- Torque socket wrench
- Pickle fork
Cradle
- 3/32" Allen socket driver
- 1/2” Open-end wrench
- Torque socket wrench
Scale
- T25 Torx
- #0 Phillip screwdriver
- #1 Phillip screwdriver
- Phillips head torque screwdriver
- T25 socket driver
- 5/64" Allen socket driver
- 1/8" Allen socket driver
- 5/32" Allen socket driver
- 1/4" Allen socket driver
- 3/8" socket
- 7/16" socket
- 3/16" Allen socket driver (Load beam only)
- 3/32" Allen socket driver (Load beam only)
- Torque socket wrench
Connector types
Disassembly and repair procedures require that you disconnect and reconnect the following connector types inside
the device:
• Locking (squeeze-release): Locking connectors use a latching mechanism to prevent accidental disconnection
during assembly and use. The latch is located on one end of a tab so it may flex and lock into place when coupled
with its matching connector. The tab provides a lever to release the latch. Some connectors have multiple latches
that require you to press multiple tabs to release.
To Next Page
Loading...
