Welch Allyn Spot VS100 - To Charge the Vision Screener

The first time you turn on the vision screener, the device guides you through
selecting the language and setting the date and time.
If the power indicator
light is... The vision screener is...
Flashing green
Charging
Steady green
Fully charged
Dark
Not plugged in to a power supply
After one minute without activity, the screen dims. After five minutes without activity,
the screen turns black to conserve battery power. To activate the device, tap the screen
or press the Power button. If the screen does not light up, plug in the power cord and try
again.
To charge the vision screener
Turn on and charge the vision screener for 4 hours before first use. When the battery
reaches a very low level, the screen displays a notice to insert the power cable. If the
power cable is not inserted, the device automatically shuts down.
1. Connect the power cord to the power supply.
2. Locate the power connector on the vision screener and connect the power supply.
16 Setting up the vision screener Welch Allyn
®
Spot
™
Vision Screener Model VS100