To add/change the security type
1. Use the radio button to select the security type: WEP, WPA/2 PSK, or WPA/2 EAP-
PEAP.
2. Touch Password.
The keyboard appears.
3. If you selected WPA/2 EAP-PEAP, enter the username and then select OK.
4. Enter the password for your organization's network, and then select OK.
5. On the Network screen, select OK to save the changes.
If you see... The vision screener is...
Successfully connected to your wireless network. The vertical bars indicate the strength of
the connection.
Not connected to the network. For tips on connecting to the network, refer to
Troubleshooting.
To enable or disable the wireless capability on the vision screener
Note If you disable the wireless capability, you must re-start the vision screener
to enable it again.
1. Touch Wireless On/Off .
2. Touch Enable or Disable.
To configure network IP settings
1. Touch TCP/IP.
The network address and settings display on the screen.
2. To manually configure the network IP configuration, touch Static. When finished,
touch OK.
3. Touch OK to save the changes and return to the previous screen.
Printing
To print screening results, you must connect the vision screener to a printer on a
wireless network or connect to a printer using a USB cable. Set the printer you want to
print to as the default printer. The vision screener is capable of printing to most wireless
network printers. However, it is not guaranteed that every printer works with the vision
screener.
The Available Printers screen displays all the printers that have been added to the vision
screener. For most printers, all you need to do to print is select the printer from the Add
Printers screen, add it to the Available Printers screen, and set it as the default printer.
For more information, see To add a printer.
26
Advanced settings on the vision screener Welch Allyn
®
Spot
™
Vision Screener Model VS100
To Next Page
Loading...
