Wellav DMP900 - Configuring Network Via Front Panel

DMP900 User Guide
4
When you take the equipment from a cold condition into a much warmer and humid
condition, the equipment should be acclimated to the warm and humidity condition for at least 30
minutes. Powering up a non-acclimated unit may lead to shortcut or other damage to electronic
components.
A professional UPS system is recommended for better performance of your content
distribution system.
2.3 Configuring Network via Front Panel
The following chart presents the Menu Structure on the Front Panel:
Main Menu
Ethernet
Host IP Address
Host Subnet Mask
Host Gateway
Host MAC Address
Trap IP Address1
Trap IP Address2
System
Language
Factory Setting
Power Alarm
Version
Mainboard Version
Sub board/Slot Version
To configure DMP900 network, use the following steps:
1. Press MENU button to enter Main Menu.
2. Use Up, Down, OK button to navigate and enter submenus.
3. In order to change the addresses, press OK button to enter edit mode. When a short line
appears under editable digit, press Up or Down button to change the digit, then press Left or
Right button to edit next digit. Press OK button to confirm and exit edit mode.
4. Press MENU at any time to return to previous menu.
DVBCommunity - cообщество профессионалов ЦТВ
https://dvbcommunity.ru/