DMP900 User Guide
2
1.2 Rear Panel
1. Dual AC Power Supply
2. Slots for maximum 6 modules
Note the position of each slot on rear panel. Fasten the modules in the chassis by screws to avoid
loose connection between the modules and mainboard.
Port Sequence on the Modules
Take 4-channel HDMI encoding module for example, from left to right the ports are port1, port2,
port3 and port4.
The DMP00 is cooled via forced induction through the front of the unit and exhausted through
the slots in the rear of the chassis. The DMP900 is equipped with a temperature controlled status
indicator. If the temperature inside the chassis exceeds 50°C (the default alarm threshold) the
mainboard status indicator will be flashing red on the front panel.
To Next Page
Loading...
