EasyManua.ls Logo

WELLTEC ACN18 - Error table

Default Icon
65 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.Welltec.pro 26
Error table
Errors are displayed on the device control panel.
Error Suggested action
E1
A room temperature sensor error has occurred.
Contact your dealer.
E2
Full tank error. To correct this error, remove the
rubber cap from the lower condensation drain hole
and connect the drain tube to it. After removing the
water, restart the unit.
E3
Evaporator temperature sensor error. Contact your
dealer.
E4
Full tank e
rror. To correct this error, remove the
rubber cap from the lower condensation drain hole
and connect the drain tube to it. After removing the
water, restart the unit.
FAQ
Question: Can I use the air conditioner right out of the box?
Answer: This is highly not recommended. The air conditioner must stand upright for 8 to 12
hours before initial start-up. This prevents damage to the compressor.
Q: Why doesn't the air conditioner lower the temperature?
A: Make sure all doors and windows of the cooled room are closed. On sunny days, run the
air conditioner early to prevent the room from heating up. It is also recommended to remove
all heat sources from the room.