WELLTEC ACN18 - Remote control; Startup; Mode; Raising the temperature

www.Welltec.pro 14
Remote control
The remote control signal is transmitted via infrared.
Startup
Press the „POWER”
button on the
remote control to turn the unit on or off.
Attention.
The compressor of the unit
starts 3.5 minutes after turning on. This
means that the air conditioner will only
start cooling or heating after this time
has elapsed
POWER
Mode
Press the „MODE” button on the remote
control to change the operating mode
of the unit.
MODE
Raising the temperature
Press the button „TEMP+”
on the
remote control to raise the set
temperature by 1°C
. The maximum
possible temperature setting is 31°C.
TEMP+
Temperature reduction
Press the button „TEMP-” on the remote
control to lower the set temperature by
1°C. The minimum temperature setting
is 16°C.
TEMP-
Fan speed
The fan speed can be selected using the
„SPEED” button on the remote control.
SPEED