www.Welltec.pro 13
Usage
Sleep Mode
Press the „SLEEP” button on the panel to turn on. If the air conditioner
is in cooling mode, the unit will raise the target temperature by 1°C after
one hour. After two hours, the temperature will increase by a maximum
of 2°C.
In heating mode, the air conditioner will lower the target temperature
by 1°C after one hour of operation. After two hours, the temperature
will drop a maximum of 2°C.
Swing mode
Press the „SWING” button on the control panel to start the air outlet
louver oscillation.
Full tank
When the unit's water tank is full, the „FULL” light will illuminate on the
control panel. The display may also show the error code E4 or E2. In this
case, empty the tank by connecting the condensate drain tube to the
lower condensate drain hole.
FULL
WiFi control
Press the „SPEED” button for 5 seconds to start WiFi pairing or to reset
the WiFi module. For more information about the first connection, see
page 19.
WIFI
To Next Page
Loading...