CP600 Pivot Operation Manual
POM-EN-December 2018
17
4. Each input and output shaft should be checked for excessive endplay after each crop cycle.
Disconnecting the driveline coupler & tapping the input shaft on both sides with a dead blow
hammer or mallet does this. If play is present, input shims should be installed to eliminate
bearing backlash.
5. All cover and end cap bolts should be torqued to 28-31 ft.-lbs (38-42 N-m).
6. All wheel lug nuts should be torqued to 115-120 ft.-lbs (156-162 N-m).
7. Remove drain plug located at bottom of gearbox and completely drain gearbox. If oil is con
taminated or emulsied, ush gearbox with a cup of specied oil and let drain completely.
8. Replace drain plug and rell gearbox through top ll hole to the proper operating level
(top of worm gear) as shown below. After one or two hours the oil should be re-checked. Air
may be trapped in the gearbox during initial lling. Top o with oil as needed.
Figure 1-13.
Section 1-13
Operation, Safety & Maintenance
Power Drivetrain Maintenance
To Next Page
Loading...