Western CP600 - Page 18

To Next Page

To Previous Page

CP600 Pivot Operation Manual

POM-EN-December 2018

B. Final drive gearbox lubricants

A GL-5 SAE 140 or MIL-C-2105 gear lube must be used in nal gearboxes. Some common brands

meeting this specication are shown below. Contact your dealer or local petroleum products dis-

tributor for other equivalent products. Use of improper oil will void the gearbox warranty.

• Hector S-150 Philube 1-LB Gear Oil #140

• Chevron Gear Compound #140

• Valvoline 85-140 Gear Oil

• Mobil 85-140 Gear Oil

• Pennzoil 85-140

• Texaco Multigear Lubricant EP SAE 85W-140

• Sprinkler Lube 1200

Oil capacity is approximately 1 U.S. Gallon, (3.8 Liters).

C. In-season nal drive gearbox Maintenance:

Final drive gearboxes should be inspected periodically during the operating season, for the follow-

ing:

1. The proper oil level should be maintained at all times.

2. Contaminated or emulsied oil should be replaced with fresh oil.

3. Input seal drain holes on the nal drive gearbox should be kept clear.

4. Input & output shaft seals should be inspected for excessive leaks and re

placed if necessary.

5. Expansion chamber vent holes should be kept clean.

Note: Failure to maintain gearboxes as specied will void the gearbox warranty.

Section 1-14

Operation, Safety & Maintenance

Power Drivetrain Maintenance