Lit. No. 95748/95749, Rev. 04 21 January 1, 2017
MAINTENANCE
AFTER EACH USE
• Wash out the hopper and rinse off all external
surfaces.
• Clean out any trapped/frozen material from
between the conveyor belt and the vehicle bed
surface.
• Apply dielectric grease on all electrical
connections to prevent corrosion at the beginning
and end of the season and after each use.
• Lubricate all grease ttings with good quality
multipurpose grease.
STORAGE
The spreader can be stored on end (on its feet) for
storage; however, steps must be taken to properly
secure it.
1. Back the truck near a wall, fence, or other
permanent structure so that there is enough room
to remove the spreader but the spreader will be
against the structure when it is taken out of the
truck.
2. Remove the spreader from the truck following the
instructions in this manual.
3. Secure the spreader to the structure using chains
or straps to ensure that it cannot tip or fall.
To Next Page
Loading...
