Lit. No. 95748/95749, Rev. 04 15 January 1, 2017
OPERATING THE SPREADER – CAB CONTROL
STARTING AND STOPPING MOTOR
1. To start the spreader, press the START/BLAST
button and release. Both the START/BLAST and
OFF buttons will be backlit when motor is running.
Spreader will operate at speed selected on the
speed dial.
2. Press the OFF button to stop motor. The OFF
button operates as emergency stop when
required.
NOTE: The truck ignition must be ON to start the
spreader.
NOTE: If truck ignition is turned OFF while
spreader is running, the motor will stop.
ADJUSTING SPINNER/CONVEYOR SPEED
The speed setting can be adjusted when spreader is
either ON or OFF.
1. Turn speed dial clockwise. Speed will increase as
the number of green LEDs illuminated on speed
dial increases.
2. Turning speed dial counterclockwise will decrease
speed.
Blast/Maximum Speed
1. Press and hold START/BLAST button as long as
maximum speed is needed.
2. Release button when maximum speed is no
longer needed. The control automatically returns
to the "ON" position and the speed shown on the
speed dial.
NOTE: When blast is used, the speed dial does
not move to the maximum speed setting, but
remains at the preset speed.
Speed Dial
Off Button (Emergency
stop when required.)
Speed Button
Indicator Light
WARNING
Before starting the spreader, the driver shall
verify that all bystanders are a minimum of
25 feet away from operating spreader.
WARNING
Never operate equipment when under the
inuence of alcohol, drugs, or medications that
might alter your judgment and/or reaction time.
WARNING
Never exceed 45 mph (72 km/h) when loaded
spreader is attached to vehicle. Braking
distances may be increased and handling
characteristics may be impaired at speeds
above 45 mph (72 km/h).
WARNING
Never allow children to operate or climb on
equipment.
To Next Page
Loading...
