Lit. No. 95748/95749, Rev. 04 14 January 1, 2017
10. Install the spacer between the end of the sill and
the front of the truck bed as shown. If you do not
have a spacer, refer to the Installation Instructions
to create one. Failure to install this spacer
could result in damage to the spreader.
MOUNTING THE SPREADER
Mounting T
WARNING
Spreader shall be bolted to vehicle frame.
Do not rely on the tie‑down chains or straps
alone to hold spreader in vehicle.
CAUTION
Before drilling any holes, check both sides
of the material for any wires, fuel lines, fuel
tanks, etc., that may be damaged by drilling.
11. Fasten the spreader to the truck bed using the
mounting tabs and existing holes and hardware.
If there are no holes, refer to the installation
instructions.
NOTE: Pay special attention when drilling or
clamping dissimilar metals to aluminum bodies.
Galvanic corrosion can occur if not handled
properly. Contact vehicle manufacturer for
recommended attachment practices.
12. Install the chute cover prior to operating the
spreader.
To Next Page
Loading...
