83
■
Removal and installation of inner heat shield
■
Removal and installation of water tank
1. Use a suitable sleeve to cover the screw fixing the inner heat shield, turn it anti-clockwise until the screw can be
removed and the inner heat shield can be taken out
2. Put the inner heat shield horizontally into the cavity, place it on the corresponding screw on the rear plate of the
cavity and tighten it clockwise with 2 screws to ensure firmness
Note:
1. When fastening, use two thumbs and press with little force, so that the buckle of the steel frame can be snapped
back to the fixing part easily.
2. Make sure that the oven cavity is cooled down, and then clean it after icon disappears.
Operation process:
1. Press to raise the panel and take out the water tank
2. Open the water tank cover and clean
3. Install the water tank cover, please press the grey point in the picture to ensure it fits well
4. Put the water tank back to its original position, press to lower the panel
W3MS450_18Jan2022_OL.indd 83W3MS450_18Jan2022_OL.indd 83 18/1/2023 上午12:0718/1/2023 上午12:07
To Next Page
Loading...
