OPERATING INSTRUCTIONS
***NEVER RUN YOUR CARPET CLEANING MACHINE WITH VAN ENGINE
RUNNING!!!
VEHICLE PREPARTION
1. Park vehicle, place automatic transmission in park or standard transmission in
neutral and set emergency brake.
2. The vehicle engine must not remain running. Both the rear and side doors
should both be left in the open position to provide proper ventilation of the
machine to prevent any overheating.
A. Do not park vehicle on a lawn or close to shrubs, as heat from
exhaust or water overflow may cause damage.
B. Do not allow vacuum or solution hoses to rest against vehicle
exhaust pipe or damage will result.
C. Assure that the vehicle interior temperatures do not exceed
140 degrees. A vehicle roof vent may also be required.
D. Do not operate machine with covers or guards removed. The
machine will not properly ventilate and may overheat.
MACHINE SET-UP FOR CARPET CLEANING OPERATION
1. Assure that chemical jug has adequate chemical supply.
2. Connect an incoming water source to the water storage tank. Assure
the inline water supply valve is open and that there is an adequate amount
of water in the tank.
3. Assure that the recovery tank drain valve is closed.
4. Assure that the face panel Auxiliary valve is closed.
5. Connect the vacuum and solution hoses to the machine. Connect the
cleaning tool to the other end of the hoses and open the solution line valve.
6. Check the pump oil level and adjust as necessary.
7. Check the engine oil level and adjust as necessary.
17
To Next Page
Loading...