White Magic PRO 1900 - Single-Viscosity Oils; Multi-Viscosity Oils; Oil Filter; To Replace, Use a Filter Wrench to Remove Filter

To Next Page

To Previous Page

Maintenance Instructions for Ford Engine (continued…)

SINGLE-VISCOSITY OILS

When Outside Temp. is Consistently: Use SAE Viscosity Number:

-10°F to + 60°F

*10W

+10°F to + 90°F

20W-20

Above +32° F

-30

Above +50° F

-40

When Outside Temp. is Consistently: Use SAE Viscosity Number:

Below +10°F

*5W-20

Below +60°F

5W-30

+10°F to + 90°F

10W-30

Above -10° F

10W-40 or 10W-50

Above +20° F

20W-40 or 20W-50

MULTI-VISCOSITY OILS

* Not Recommended for severe service - Including High RPM Operation.

Oil Filter

Use a Motorcraft FL-400A Long-Life Oil Filter which meets Ford Specification ES-E1ZE-

6714-AA. These filters protect your engine by filtering harmful, abrasive, or sludgy particles

without blocking flow to vital engine parts.

To replace, use a filter wrench to remove filter.

Clean the filter mounting base. Lightly coat the gasket surface of the new filter with engine oil

and hand tighten until the gasket contacts the base, then tighten another half turn. Fill the

crankcase and run the engine to check for leaks. (Tighten filter more if necessary.)

WARNING - Do not handle a hot oil filter with bare hands. Continuous contact with used

motor oil has caused skin cancer in laboratory mice. Protect your skin by washing with

soap and water.