AUXILIARY HOT WATER OUTPUT
CAUTION
Do not use the auxiliary output if the engine is overheating or if the Cat pump is turned off.
Dangerous high pressure steam may cause severe burns.
1. To use the auxiliary output make sure the machine is properly primed
and ready to operate.
2. Attach a hose to the output garden hose fitting and open the valve.
NOTICE
The water output from the auxiliary output is not the same temperature as the output solution.
It is approximately the same temperature as the engine itself.
DUAL WAND OPERATION
The Pro-1900 system has sufficient capacity for dual wand operation with minimal pressure
loss at each wand. The pump pressure and temperature can remain at the same levels as for
single wand operation. The chemical flow rate may be set slightly higher than for single
wand operation. To set up for dual wand operation, remove the plug on the optional filter box
assembly or on the dual wand adapter elbow. For proper operation, each vacuum hose line
should be the same length. White Magic recommends running the machine at 2200 RPM for
single wand operation or 2700 RPM for dual wand operation.
26
To Next Page
Loading...