21. To disconnect a tool from the solution line, turn the solution valve to the
perpendicular “OFF” position and depress the cleaning tool trigger and discon-
nect the tool.
22. When cleaning is complete, flip the PUMP POWER switch to the “OFF”
Position.
23. Return the throttle knob to the idle position and turn the temperature
control to “LOW” then allow 2 minutes for the machine to cool down.
24. Turn the key switch to the “OFF” position.
25. Disconnect set-up and proceed to an approved waste dump area if necessary.
Close drain valve before starting the next cleaning job.
CAUTION
PROTECT EQUIPMENT FROM FREEZING
IF RECOVERY TANK BECOMES FULL, IT WILL AUTOMATI-
CALLY SHUT THE MACHINE OFF. ROTATE THE MAIN POWER
SWITCH TO OFF AND EMPTY THE RECOVERY TANK.
OPERATING INSTRUCTIONS (continued..)
19
To Next Page
Loading...