widos 5500 - Special Dangers; Danger of Catching Clothes by the Planer; Danger of Being Burnt by Heating Element, Reception Box and Welding Area; Danger of Stumbling over Electric; Hydraulic Wires

Kunststoffschweißtechnik
Safety Rules Chapter 2
17.02.14 Working Instructions WIDOS 5500 Page 13 of 48
2.11. Special dangers
2.11.1 Danger of catching clothes by the planer
You can cut yourself or even get bones broken !
 Only wear clothes tight to the body.
 Do not wear rings or jewellery during the work.
 If necessary, wear a hair-net.
 Always put the planer back into the reception box after and before each use.
 Transport the planer at the handle only. Do not touch the surfaces.
 Switch the planer on only for usage.
 If the planing pressure is too high, there is the danger that the planer tilts during planing.
For that reason do not press the pipe ends stronger than necessary against the planer. If
necessary, hold the planer firmly.
2.11.2 Danger of being burnt by heating element, reception box and
welding area
You can burn yourself, inflammable materials can be ignited.
The heating element temperature is heated up to more than 250°C !
 Do not touch the surfaces of the heating element.
 Do not leave the heating element unsupervised.
 Take enough safety distance to inflammable materials.
 Do wear safety gloves.
 Always put the heating element back into the reception box after and before each use.
 Transport the heating element at the handle only.
2.11.3 Danger of stumbling over electric / hydraulic wires
 Make sure that no person has to step over the wires.
 Lay the wires in such a way that the danger is kept to a minimum.
2.11.4 Risk of injury by noises
Noises exceeding 80 dB (A) may occur; during planing it is obligatory to wear ear
protection!