86333220 CS20 43
Maintenance
Drive Unit Removal
1. Remove tank assembly.
2. Pull the brake and drive electrical connectors off of
their support plate.
3. Remove the P-clamp holding the cable.
4. Lift the chain cover plate off of the motor.
5. Support the chassis on the tip pads so that the
front wheel is 10 inches off the floor.
6. Locate and remove two mounting nuts and remove
the drive unit from below.
7. To reinstall, reverse the process.
8. Note the small tab at the front of the drive unit
frame should line-up with the notch in the mating
plate.
To Next Page
Loading...
Need help?
General