77
Note: All receivers using this switch
must be DISH Pro Plus.
Example: DP 311 is not compatible.
DISH Pro Plus 44 Multi-Dish Switch
Run Check Switch
After you have connected your switch to the LNBFs and receivers in the system, you will need to
run Check Switch on each receiver in your system, one at a time. Follow these instructions for
each receiver:
1. Open the Point Dish/Signal Strength screen. See your DISH Network satellite
receiver user’s guide for instructions. A Point Dish/Signal screen similar to the one
shown as Figure 2 will open.
Note: Models 2800, 3900, 4900, and 6000 must select SuperDISH/129 to see the fourth port.
Figure 2 Point Dish Screen
2. Select Check Switch or Test, depending on your receiver model. The Check Switch
screen will open. Select Check or Test, depending on your receiver model.
3. The Check Switch procedure will run. When it finishes, you will see an Installation
Summary screen.
To Next Page
Loading...
