Winegard Trav'ler - Pre installation; Required Tools List

62

Level
 Tape measure
 Drill with 5/16
″
bit
 1/2
″
and 1-1/4″ hole saw
 7/16
″
open end wrench
 #2 Phillips screwdriver
 Caulk gun
 Sealant (consult RV manufacturer
for proper sealant)
The tools required for Winegard TRAV’LER satellite mobile antenna installation are:
TRAV’LER® Multi-Satellite HDTV Antennas
Pre installation
Introduction
Tools Required
Congratulations!
You have selected the Winegard
TRAV’LER Automatic Multi-Satellite
TV Antenna. The TRAV’LER will
deliver the ability to view up to five
satellites at the same time with
unmatched signal strength, the lowest
travel height on the market, maximum
HD capabilities and easy to use
functionality – just like you get at
home.
This course provides important
information on the installation and
operation of your Satellite Interface
Box. After completing this course, you
will be able to understand the steps
involved in installing and operating
TRAV’LER antennas.