WinGD WARTSILA RT-flex58T-E - Bedplate and Tie Rod (Group 1); Main Bearing; Thrust Bearing; Cylinder Liner and Cylinder Cover (Group 2)

RT-flex58T-E
Maintenance0002−1/A1
Table of Contents
2/ 5 Winterthur Gas & Diesel Ltd.
2015-08
Bedplate and Tie Rod Group 1
Bedplate and Thrust Bearing: Checking the Foundation Bolts 1112−1/A1.................
 Main Bearing
− Loosening and Tensioning of Elastic Studs 1132−1/A1..............................
− Removal and Fitting of a Main Bearing 1132−2/A1.................................
 Thrust Bearing
− Checking the Axial Clearance 1203−1/A1.........................................
− Removal and Fitting the Thrust Bearing Pads 1224−1/A1............................
Engine Stays with Friction Shims: Checking the Pre-tension 1715−1/A1..................
Tie Rod: Checking the Pre-tension and Tensioning the Tie Rods 1903−1/A2..............
Cylinder Liner and Cylinder Cover Group 2
 Cylinder Liner
− Measuring Bore Wear 2124−1/A1................................................
− Removal and Fitting 2124−2/A1..................................................
− Removing the Wear Ridge, Re-dressing Lubricating Grooves
and Scavenge Ports 2124−3/A1..................................................
Lubricating Quill with Pulse Jet
Lubrication: Removal and Fitting 2138−1/A2..............
Piston Rod Gland: Dismantling and Assembling, Measuring the Wear 2303−1/A1.........
 Cylinder Cover
− Removal and Fitting of Cylinder Cover and Water Guide Jacket 2708−1/A1............
− Loosening and Tensioning of Cylinder Cover Elastic Studs 2708−2/A1................
− Machining of Sealing Face for Injection Valve 2708−3/A1............................
Injection Valve with FAST
: Checking, Dismantling, Assembling and Adjusting 2722−1/A2...
Starting Air Valve: Removal, Fitting and Dismantling, Grinding-in and Assembling2728−1/A1
Relief Valve for Cylinder Cover 2745−1/A1...........................................
 Exhaust Valve
− Removal and Fitting of Exhaust Valve, Replacing of Elastic Studs 2751−1/A1..........
− Dismantling and Assembling 2751−2/A1..........................................
− Replacing and Grinding the Valve Seat 2751−3/A1.................................
− Grinding the Seating Surface on the Valve Head 2751−4/A1.........................