English | 3 | Machine description
16 | 89014484; Version 1 | Operating instructions MT Series
3.7 Chemicals
Operate the warewasher with chemicals from Winterhalter. Contact Winterhalter or an authorised customer service team
before using other chemicals.
Rinse aid
Rinse aid is required to ensure that water on the wash items runs off as a thin film after washing. This helps the wash
items to dry quickly.
Rinse aid is automatically dispensed using an external dosing device.
Winterhalter dosing devices can dispense two different types of rinse aid (e.g. one for glasses and one for canteen trays).
Each of the configured types of rinse aid can be assigned to a particular transport speed.
Detergent
A detergent is required to dissolve food residues and dirt on the wash items. Detergent is automatically dispensed using
an integrated or external dosing device.
To avoid damaging the warewasher and to achieve a good wash result:
– Do not use acidic detergents.
– Do not use foaming products (e.g. manual washing-up liquid) for pre-treating the wash items.
Warewashers with Winterhalter dosing devices can operate using two different types of detergent (e.g. one for glasses
and one for dishes). After changing the type of detergent, the tank water must be changed.
3.8 Suction tube with level control
Colour
(cover cap)
Canister
Orange Defoamer
Grey Detergent
Blue Rinse aid
The float switch (1) can detect a defect in the chemicals and indicates this on the display (} page 37).
3.9 Main switch
The warewasher can be disconnected from the electrical
mains supply using the main switch.
– Horizontal position: all poles of the warewasher are dis-
connected from the electrical mains supply
– Vertical position: The warewasher is connected to the
electrical mains supply
Note:Risk of damage to heat pump! The warewasher
must not be switched off using the main switch. Switch off
the warewasher using the display and wait 15 seconds be-
fore switching off the main switch.
To Next Page
Loading...
Need help?
General
