Winterhalter STR series User Manual

Maintenance and care
13
8.1.5 Cleaning the outside of the machine
 Clean the exterior surfaces with a stainless steel cleaner and stainless steel polish.
 Clean the connected table system.
8.1.6 Checking external water treatment
 Check whether sufficient regeneration salt has been added.
8.2 Monthly
8.2.1 Cleaning the dirt trap
 Clean the debris filter in the dirt trap.
8.2.2 Descaling
If the machine is operated with very hard water and without suitable water treatment, limescale can build up
in the boilers, the interior of the machine and in all pipes that carry water.
Limescale deposits and the incorporated dirt and grease residues represent a hygiene risk, and the
limescale can cause the heating elements to fail. Therefore, it is essential to remove these deposits at
regular intervals.
The job of correctly descaling the boilers and all pipes that carry water should be entrusted to a Winterhalter
service technician.
However, you can descale parts of the interior of the machine yourself by following the instructions below.
 Drain the machine ( 8.1.1).
 Interrupt the dosing of detergents (e.g. pull out the suction tube or switch off the dosing equipment) in
order to prevent chlorine gas from being formed if the active chlorinated detergent comes into contact with
descaler.
 Fill the machine ( 7.1.2).
Warning
When using chemicals, comply with the safety notes and recommended dosages printed on the
packaging.
Wear protective clothing, protective gloves and protective goggles when handling chemicals.
 Add the descaler to the tank of the machine in accordance with the recommended dosage.
 Run the machine with empty washing racks until all the limescale deposits have been removed.
 It may be necessary to dose additional descaler after an operating time of about 10 minutes.
 Drain the machine ( 8.1.1).
Caution
The descaler may not remain in the machine for several hours.
 Fill the machine ( 7.1.2).
 Run the machine with empty washing racks in order to remove descaler residue from the washing
system.
 Drain the machine ( 8.1.1) again.
 Put the detergents dosing into operation again.

Winterhalter STR series Specifications

General

Dimensions	Varies by model
Booster heater power	Varies by model
Total connected load	Varies by model
Weight	Varies by model
Control	Electronic control
Features	automatic detergent dosing
Rack size	500 x 500 mm
Power consumption	Varies by model
Dimensions (HxWxD)	Varies by model
Drying system	Residual heat drying