The tank of the main wash zone and the boiler are filled and heated up automatically.
Detergent is dosed into the tank of the main wash zone (assuming dosing equipment is connected).
Button 3 lights up red until the rated levels in the tank and boiler are reached.
Before the rated temperatures have not been reached, the temperatures in displays A (boiler) and B
(tank) are shown. After this point, the temperatures displayed disappear.
The following signify together that the machine is ready for operation:
Button (3) lights up green.
Button (5) lights up yellow and blinks.
Button (6) lights up yellow.
INFO: The machine is supplied from the factory programmed so that it can be started as soon as the rated
levels in the tank and the boiler are reached. Alternatively, the machine can be programmed so that it can
only be started after the rated temperatures have been reached. Contact a Winterhalter service technician.
7.2 Washing
The machine can be operated with two different transport speeds.
The machine is pre-set to slow-speed
transport: Button 5 blinks.
Press button 3 to start rack conveyor
transport.
Button 3 lights up blue.
If you want to increase the transport
speed, press button 6.
Button 3 lights up green shortly, then
blue.
Button 6 blinks.
Button 5 lights up.
If you want to stop rack conveyor
transport, press button 3.
Button 3 lights up green.
To Next Page
Loading...
Need help?
General
