Winterhalter UF-L - Operating Data

PIN menu
16
Programming automatic switch off
 Tap the following buttons in turn:
The setting of days of the week or special dates is much the same as for automatic switch on. Proceed as
described in this section.
Sequence of the automatic switch off
3 short
beeps

10 s
pause

3 short
beeps

10 s
pause

3 short
beeps

Machine is emptied and switched off
using the self-cleaning programme
INFO If the door is open during the automatic switch-off, the machine is pumped empty and switched off,
but not cleaned inside.
7.3 Operating data
Here you can read out all operating data.
Retrieving the operating data
 Press the button.
The following operating data is shown on the display.
Commissioning
Date
Next service in
①
x hours or washing cycles
Total operation hours
x hours
Total washing cycles
x
Total water consumption
x litres
Full washing cycles Energy
②
x
Total energy savings
②
x kWh
Op. hours/day
x hours
Washing cycles/day
x
Water consumption/day
x litres
Remaining capacity water treatment
x litres
Operating hours Master old
③
x hours
INFO The display depends on the facilities of the machine.
 Press the back button to exit from the menu.
①
An authorised service technician can activate this function.
②
only for Energy models
③
when a new display is installed