Winterhalter UF-L - Page 20

PIN menu
18
Starting the descaling programme
 Tap the following buttons in turn:
 The button flashes while the
programme is running.
Warning
Descaler causes corrosion
The descaling solution must not remain in the machine. If you switch off the machine when the
descaling programme is in progress or if you terminate the programme, the machine must be
emptied, refilled and again emptied. Use the self-cleaning programme for this.
Sequence of the descaling programme
 Open door.
 Close door.
 Open the door and check the result:
 Continue with step 8.
 Close the door and repeat steps 5 + 6.
 Close door.
 Put descaler
(A 70 LS) into the
tank:
UF-M/UF-L: 690 ml
UF-XL: 1380 ml
Add descaler.
Press start button.
Test descaling.
Good: Press button 28.
Bad: Press start button.