WKS i3 - Installation Tools

10 / 47

Maximum altitude: 2000m
3.4. Installation Tools
The following tools shall be prepared before installation:
No. Tool Model Function
1
Hammer drill
Recommend drill dia.6mm
Used to drill holes on the wall
2
Screwdriver wiring
3
Wire stripper Strip wire
4
4mm Allen Key
Turn the screw to connect rear panel
with inverter
5
Crimping tools Used to crimp power cables
6
Multi-meter Used to check grounding
7
Marker pen Used to mark signs
8
Measuring tape Used to measure distances
9
Level
Used to ensure that the rear panel is
properly installed
10
ESD gloves Operators wear