WKS i3 - Event List

36 / 47
7. Battery Active
7.Battery Active
1.Auto Active Control
Enable
Disable
2.Force Active
WKS I inverter can activate flat batteries when needed.
The user can enable “Auto Active Control” to allow WKS I inverter to activate flat batteries automatically. Or make
WKS I inverter to activate the battery right away.
8. DRMs0 control
Select “8. DRMs0 Control”, press “OK”, press “up” or “down” to select “Enable DRMs0” or “Disable DRMs0”, press
“OK”.
9. Safety Param.
9.Safety Param.
1.Set START Parameters
2.Set Safety Voltage
3.Set Safety Frequency
4.Set Insulation
Copy the TXT file to the root directory of SD card.
Select “9. Safety Param.”, press “OK”, press “up” or “down” to select “1. Set START Parameters”, “2. Set Safety
Voltage”, “3. Set Safety Frequency” or “4.Set Insulation”, then press “OK”.
Please contact WATTUNEED technical support for more information.
6.4.3. Event List
3.Event List
1.Current Event List
2.History Event List
Event list of WKS I inverter, including current event list and history event list.
1) Current Event List
Select “1. Current Event List”, press “OK” to check the current events.
2) History Event List
Select “2. History Event List”, press “OK” to check the historical events. Press “up” or “down” to check all historical
events if there’re more than 1 page of events.
“Up”
↑
“Down”↓
“Up” ↑
“Down”↓
“Up”
↑
“Down”
↓