WKS i3 - Basic Settings Configuration

To Next Page

To Previous Page

26 / 47

6.4.1. Basic setting:

1. Set Language

Select “1. Language”, press “OK”. Press “up” or “down” to select the language and press “OK”.

Easier Way: press “Back” & “OK” at the same time to change system language.

2. Set Time

Select “2. Time”, press “OK” to enter time setting interface, system time format is 20YY-MM-DD HH:MM:SS

Press “Up” or “Down” to change the 1

digit, press “OK” to switch to next digit, after inputting the current time,

press “OK”.

3. Energy Storage Mode

Select “3. Energy Storage Mode”, press “OK” to enter energy storage mode setting interface.

3.Energy Storage mode

1.Set Auto Mode

2.Set Time-of-use Mode

3.Set Timing Mode

4.Set Passive Mode

1) Set Auto Mode

Select “1. Set Auto Mode”, then press “OK”.

In auto mode, WKS I inverter will automatically charge & discharge the battery.

1.Basic Setting

Press “OK”

Up” ↑

“Down”

↓

1.Language

2.Time

3.Energy Storage Mode

4.PV Input Mode

5.EPS Mode

6.Communication Addr.

7.Auto Test

“Up” ↑

“Down”↓