WMF 1300 S - Initial Start-up Program

28
User Manual WMF1300S
Start-up | Start-up program
 Observe the technical data
 Plug the power cord for the coffee machine into an
appropriate electrical outlet
• For commissioning, fill the water tank with
fresh drinking water.
3.3 Start-up program
 Switch-on the coffee machine using the ON/OFF
switch
Coffee machine switches on.
The start-up program starts.
 Follow all the instructions on the display
The start-up program provides astep-by-step
guide through the remaining start-up steps on
the display.
> Follow the display messages.
• The set values can be changed after start-up.
Additional instructions
• Connect up the milk w Chapter 4.3.1page 32
As soon as the start-up program has run through
completely and all necessary adjustments have been
made, the coffee machine will restart. Calibration is
performed fully automatically.
Burn hazard/scalding hazard
• When dispensing beverages, hot liquid comes
out of the spouts. The adjacent surfaces and
spouts become hot.
> When dispensing beverages, do not reach
beneath the spouts.
> Do not touch the spouts immediately after
dispensing.
Technical data
w page 125
NOTE
IMPORTANT
Change settings
w Software
starting on page 46
CAUTION
Follow the Safety chapter
w starting on page 5