Right grinder The grinder on the right is pre-set to grinding degree 1, espresso grind.
This corresponds to a discharge rate of about 2.2 g/s, and a grain size distribution of about 470 μm.
Left and center grinder The center / left grinder is pre-set to grinding degree 5, creme grind.
This corresponds to a discharge rate of about 2.6 g/s, and a grain size distribution of about 640 μm.
Note: When the grinder disks or grinder have been replaced, reset the grinder counter.
Service > Service date > Grinder 1 grinder disk / Grinder 2 grinder disk > Confirm Maintenance
2.4.1 Mechanical basic settings
This setting is made with the grinder completely empty, without the adjustment motor, outside of the machine
Turn the disks together with the crown gear assembled until the disks are seated together and can no longer be
turned on the drive shaft by hand.
Adjust basic setting for grinding degree
The seam on the grinder outlet can be used as a visual guide here; see illustration.
Turn the top grinder disk to open it by 10 teeth, corresponding to grinding degree 1 - espresso grind
Turn the top grinder disk to open it by 18 teeth, corresponding to grinding degree 5 - crème grind
2.4.2 Using the electrical grinding degree setting on the grinder
Install the adjusting motor and place the grinder in the machine
Enter the mechanically grinding degree setting under Service > Machine data > Enter grinding degree setting
The software limits the range for the setting to prevent it from locking up
When needed see grinding degree using System > Set grinding degree > Grinding degree grinder 1 / Grinding degree grinder 2 nachstellen
Perform portioner calibration
To Next Page
Loading...
