WMF 9000 S+ - Page 15

15
User Manual WMF9000S +
Safety
Installation location
• The device can be used as aself-service device if it is supervised
by trained personnel.
The machine must be set up so as to allow good visual access.
•
The device must be placed and levelled on ahorizontal, sturdy,
water-resistant, and heatproof base.
• The device must not be cleaned using awater jet. The device
must be installed where it is protected against water spray.
• The device must not be located on asurface that is sprayed or
cleaned with awater hose, steam jet, steam cleaner, or similar
devices.
Water supply
• TW10 (DN 10at least DN 6or 3/8") hose connector with main
water supply and contaminant filter, with amesh size of
0.2mm to 0.25mm, by customers on-site.
At least 0.05MPa (0.5bar) supply pressure at 2l/min.
Maximum 0.6MPa (6bar). Low pressure: min. DN6or 1/4".
Maximum inlet temperature 35°C.
• The set of hoses provided with the new coffee machine
and/orthe new water filter must be used. Do not use the old
set of hoses.
Ambient temperature
• Ambient temperature +5°C to amaximum of +35°C