WMF 9000 S+ - Filling the Milk System (Dynamic Milk); Drip Tray Cleaning; Settings; Switch-Off Rinsing

43
User Manual WMF9000S +
Software | Care
Filling the milk system (DynamicMilk)
This function fills the milk system for dispensing cold
beverages.
 Touch Milk system rell
Drip tray cleaning
The cup table moves upward when the “Drip tray
cleaning” pad is touched. The drip tray can then be
cleaned.
Settings
Switch-off rinsing
Options: • active
• inactive
Default value:
active
active
When the coffee machine is switched off,
the switch-off rinsing must be run if milk
beverages have been dispensed since the last
time the machine was cleaned.
Preparing the milk system after cleaning
Options: • active
• inactive
Default value:
inactive
active
After the milk system cleaning cycle, the
machine shuts down normally. If this function
is activated, the user can replace and connect
the milk container up to 15minutes after
cleaning. The coffee machine is then ready to
run again.
Milk system rell
DS_04_03_08
Drip tray cleaning
DS_04_03_09
Clean the drip tray
w Care
page 84
Settings
DS_04_03_10