WMF 9000 S+ - Milk Foam Selection; Logo; Manufacturers Logo; Customers Logo

58
User Manual WMF9000S +
Software | Operating options
Milk foam selection
Options: • active
• inactive
Default value:
active
Logo
Manufacturer's logo
Options: • active
• inactive
Default value:
active
active The manufacturer's logo is shown at the top
right of the “Ready to operate” display.
Customer’s logo
Options: • active
• inactive
Default value:
inactive
active When the option is set to “active” and
acustomer’s logo has been downloaded, the
customer’s logo is shown at the centre of the
header bar when “Ready to operate”. When
the vending devices are connected it shows
the customer’s logo. In this case, both logos
cannot be displayed.
Load customer's logo
Insert the USB stick containing the customer’s logo.
Load the customer’s logo.
Size of customer’s logo
The logo must not be greater than 80pixels high.
Larger logos will be scaled to this size automatically.
Milk foam selection
DS_04_05_09
Milk foam selection is possible only
with AutoSteam option.
Logo
DS_04_05_10