WMF espresso NEXT - Cup Heating; Grinding Degree Setting

67
UserManualWMFespressoNEXT
Software | System
Cup heating
The cup heater is switched on and off here.
Options: • active
• inactive
Default value:
inactive
Grinding degree setting
The grinding degree can be adjusted from the display.
Lower number -> finer grinding degree
Higher number -> coarser grinding degree
The setting has intervals of 0.25. Adjust the grinding
degree by no more than 0.5each time.
The grinder must be run between each setting.
Only for trained personnel and service.
After the grinding degree setting has been adjusted,
there may be differences between the setting and
the actual metered ground coffee quantity. These
differences may cause errors in the Dynamic Coffee
Assist function.
This manual setting can only be changed after
“Dynamic Coffee Assist” has been deactivated.
Cup heating
Grinding degree setting
w Dynamic Coffee Assist
page 68
NOTE