WMF I800S - Mixer Rinsing; Customer Check-Up (Optional); Filter Change; Rinse Filter

25
User Manual WMF1800S
Software, Care
Mixer rinsing
The mixer lift must be in the top position.
 Touch
mixer rinsing
Mixer rinsing starts.
Mixer rinsing is performed automatically by the cleaning
program when amixer system is installed.
Filter change
If the filter capacity is exceeded, there will be amessage
once per day that afilter change is due.
The filter must be changed within one week; otherwise, the
message will be displayed after every brew.
 Change filter
 Confirm filter change
After filter change there is an automatic program
sequence to rinse and bleed the anti-scale filter and water
system. Hot water runs out of the hot water spout during
this process.
Rinse filter
The Filter rinse option enables water system and filter
rinsing and bleeding following long intervals in operation.
 Touch
filter rinsing
Hot water runs out of the hot water spout during this
process.
Customer Check-up (optional)
This point can be selected by trained personnel if the
WMFService function has been enabled.
Question: Has customer check-up been performed?
yes/no
mixer rinsing
Caution.
Hot liquids in the
dispensing area.
Observe the Safety chapter.
filter change
Observe water filter instructions.
Displays lead step by step through
the program.
Follow the instructions.
Caution.
Scalding hazard.
Observe the Safety chapter.
filter rinsing
Caution.
Scalding hazard.
Observe the Safety chapter.