Wolf BM-2 - Heating Appliance Status Page; Using the 1 x Key for 1 x DHW Heating

3064202_201602 13
Heating appliance status page
7 Heating appliance status page
If a KM module is integrated in the Wolf control system (WRS), then up to 4 heating appliances can also be
connected. Each heating appliance is then displayed with its own status page.
7.1 Using the
1 x
key for 1x DHW heating
The special function 1x DHW bypasses the programmed switching times and heats up the DHW cylinder once,
for one hour, to the set DHW temperature.
− Once-only DHW heating (displayed for all heating appliances)
− All connected DHW cylinders are heated
− Press key 2 again to disable once-only DHW heating
− You are taken back to the home page after 5 seconds
Key 2
14:12
20.01.13
1.5 bar
1 x
Once-only
DHW heating
enabled
Heating appliance
Heating mode
1 x
Burner ON
Pressure
14:12
20.01.13
1.5 bar
25.2
°C
1 x
Boiler temperature
Heating appliance
Heating mode
Burner ON
Pressure
1x DHW heating
enable
Screen display
changes
Key 2
14:12
20.01.13
1.5 bar
25.2
°C
1 x
Boiler temperature
Heating appliance
Heating mode
Burner ON
Pressure
1x DHW heating
disable
14:12
20.01.13
1.5 bar
1 x
Once-only
DHW heating
disabled
Heating appliance
Heating mode
1 x
Burner ON
Pressure
Screen display
changes