Wolf BM-2 - Using the Key for Emissions Test Mode

14 3064202_201602
Heating appliance status page
7.2 Using the key for emissions test mode
− Variable functions (e.g. enabling emissions test).
− Emissions testing is only displayed if the BM-2 is installed in the heating appliance.
Once the emissions test function (key 3) has been enabled, the burner runs for 15 minutes and the time counts
down on the display. The time can be extended back to 15 minutes by pressing key 3 again.
Key 2
14:12
20.01.13
1.5 bar
25.2
°C
1 x
Boiler temperature
Heating appliance
Heating mode
Burner ON
Pressure
Key 3
Key 4
Back one level
Extend time
Home page
14:12 20.01.13
20 °C
40.0
°C
T_return
Boiler temperature
Flue gas test
Flue gas test active
08 min
Rem. time
14:12 20.01.13
20 °C
40.0
°C
T_return
Boiler temperature
Flue gas test
Flue gas test active
15 min
Rem. time
Key 3
14:12
20.01.13
1.5 bar
25.2
°C
1 x
Boiler temperature
Heating appliance
Heating mode
Heating mode ON
Pressure
Flue gas test
Screen display
changes
Screen display
changes
Screen display
changes
Screen display
changes
14:12 20.01.13
20
40.0
°C
T_return
Boiler temperature
Flue gas test
Flue gas test active
15 min
Rem. time
14:12 20.01.13
20 °C
40.0
°C
T_return
Boiler temperature
Flue gas test
Flue gas test active
08 min
Rem. time
14:12 20.01.13
20 °C
40.0
°C
T_return
Boiler temperature
Flue gas test
Flue gas test active
08 min
Rem. time
"White" ame =
lower load (20 %)
"Red" ame =
upper load (100 %)
14:12 20.01.13
20
40.0
°C
T_return
Boiler temperature
Flue gas test
Flue gas test active
15 min
Rem. time