Wolf FGB-35 - Standards and Regulations

12
3064458_201811
Observe all standards and guidelines applicable to the installation and
operation of this heating system in your country.
Observe the information on the boiler type plate.
The following local regulations must be complied with during installation and
operation of the heating system:
• Siting conditions
• Ventilation and exhaust air facilities and connection to a chimney
• Electrical connection to the power supply
• Technical regulations of the gas supply utility company regarding the connection of
the gas appliance to the local gas mains
• Regulations and standards regarding the safety equipment of the water heating
system
• DHW installation
6. Standards and regulations
The following general regulations, rules and guidelines must be observed for
installation in particular:
• (DIN) EN 806 Specications for installations inside buildings conveying water for
human consumption
• (DIN) EN 1717 Protection against pollution of potable water installations
• (DIN) EN 12831 Heating systems in buildings – Method for calculating the design
heat load
• (DIN) EN 12828 Heating systems in buildings – Design of water-based heating
systems
• (DIN) EN 13384 Chimneys – Thermal and uid dynamic calculation methods
• (DIN) EN 50156-1 (VDE 0116 Part 1) Electrical equipment for furnaces and
ancillary equipment
• VDE 0470/(DIN) EN 60529 Degrees of protection provided by enclosures
• VDI 2035 Prevention of damage in water heating installations
- Scale formation (Sheet 1)
- Water-side corrosion (Sheet 2)
- Corrosion by fuel gases (Sheet 3)