Preparing the sharpener for sharpening VORTEX blades
Grinding Wheel and Oiler Replacement
Preparing the sharpener for sharpening VORTEX bladesISHdoc1213194-1
4
SECTION 4 PREPARING THE SHARPENER FOR SHARPENING
VORTEX BLADES
DANGER! Before replacing any sharpener component, disconnect the
power cord.
IMPORTANT! To increase the Vortex blade life, the time intervals
between sharpenings should not be longer than one hour.
4.1 Grinding Wheel and Oiler Replacement
1. Unscrew the wing screws (B) and dismount the grinding wheel cover (A).
2. BMS500: unbolt the mounting hardware (A) and remove the oiler (B).
FIG. 4-1
FIG. 4-2
To Next Page
Loading...
