Preparing the sharpener for sharpening VORTEX blades
Blade Pusher Adjustment
Preparing the sharpener for sharpening VORTEX bladesISHdoc1213194-7
4
4.3 Blade Pusher Adjustment
Using the adjustment nuts (A), adjust the blade pusher (B) so that it pushes the next tooth after the
tooth to be sharpened.
4.4 Sharpener Head Adjustment
Use the bolt shown below (A) to raise the sharpener head (B) by 3 to 4 mm.
FIG. 4-13
FIG. 4-14
To Next Page
Loading...
